Hey Guys,
Once again... you can buy these...
It was quicker for me to just make the size I needed...
It works good enough for me... Gets the screw head "Flush"...
That was all I was asking of it...
.
The Pictures are self explanatory...
Basically, I laid out the same parts used to make it...
and took a picture.
.
That outta be worth ten thousand words right there...
.
Gotta Fly...
.
.
Dimpler - Homemade
- planecrazzzy
- Site Admin
- Posts: 1154
- Joined: Sat Jan 01, 2005 1:23 pm
- Location: Minnesota
- Contact:
Dimpler - Homemade
You do not have the required permissions to view the files attached to this post.
Sometimes you just have to take the leap
and build your wings on the way down...
Gotta Fly...
and build your wings on the way down...
Gotta Fly...
- planecrazzzy
- Site Admin
- Posts: 1154
- Joined: Sat Jan 01, 2005 1:23 pm
- Location: Minnesota
- Contact:
Re: Dimpler - Homemade
.
I thought I would post some examples of where I used this tool .
.
I also used them on the rear window frames , then they were covered by fabric .
.
Its not the perfect dimpled hole , but it does the job .
.
If had a lot of holes that needed this , I'd buy the tool .
.
Gotta Fly...
.
I thought I would post some examples of where I used this tool .
.
I also used them on the rear window frames , then they were covered by fabric .
.
Its not the perfect dimpled hole , but it does the job .
.
If had a lot of holes that needed this , I'd buy the tool .
.
Gotta Fly...
.
You do not have the required permissions to view the files attached to this post.
Sometimes you just have to take the leap
and build your wings on the way down...
Gotta Fly...
and build your wings on the way down...
Gotta Fly...