TIPS & HINTS

For general discussion of the Just Aircraft family of aircraft.
Includes: Highlander, Escapade, Summit and SuperSTOL.
Post Reply
ALTAWINGMAN
New Member
Posts: 4
Joined: Wed Sep 13, 2006 11:19 pm

TIPS & HINTS

Post by ALTAWINGMAN »

HI GUY'S ALTAWINGMAN HERE WITH KIT #120 IN CALGARY ALBERTA CANADA THIS FORM IS GETTING LOTS OF INTREST I AM ENJOYING THE TIPS AND HINTS THERE GREAT' I JUST THOUGHT I WOULD LEAVE SOME THINGS I HAVE HAD GOOD LUCK WITH  MIXING HYSOL  PLASTIC SPOONS TO MEASURE AND POPSICLE STICKS LARGE SURINGE WITH SMALL TUBE MAKES NICE FILLETS . PUTTING IN I BEAM AFTER LIGHTLY SANDING WITH SCOTCHBRITE PAD THROW IN SNOW BANK TO COOL I BEAM DOWN 'HEAT WINGSPAR WITH HEATGUN PUT LITTLE WD40 ON COLD I BEAM PUSH RIGHT IN NO PROBLEM. FLAPS / AL FIBERGLASS LEADING EDGE  FIND THE SMALL PLYWOOD FILLER PIECES THE ONE'S THAT GO BETWEEN THE LE RIBS USE ONE FOR A TEMPLATE DRAW A LINE BETWEEN THE TWO HIGH SPOTS ON BOTH SIDES THEN PUSH IN THE FIBERGLASS AT EACH END TO MARK WHERE TO TRIM THE FIBERGLASS STRIP .   TO LINE UP PULLEYS ;  BEND A PIECE OF PIANO WIRE AROUND THE PULLEY THEN  USE IT FOR A ALIGNMENT TOOL.. A MUST TOOL IS 1/4 INCH 90DEG AIR DIE GRINDER WITH 2 INCH ROLOK DISKS 80 GRIT AND 60  . THANKS FOR NOW HAPPY BUILDING  ;    ALTAWINGMAN CALGARY ALBERTA
Post Reply

Return to “Just Aircraft”