SuperStol Fabric Backing Plates & Elevator access plates

For general discussion of the Just Aircraft family of aircraft.
Includes: Highlander, Escapade, Summit and SuperSTOL.
User avatar
CanadianSheepHunter
Veteran Member
Posts: 678
Joined: Thu Feb 26, 2015 1:05 pm

Re: SuperStol Fabric Backing Plates & Elevator access plates

Post by CanadianSheepHunter »

Flying wires lower attach point. Added after shrinking.
You do not have the required permissions to view the files attached to this post.
User avatar
CanadianSheepHunter
Veteran Member
Posts: 678
Joined: Thu Feb 26, 2015 1:05 pm

Re: SuperStol Fabric Backing Plates & Elevator access plates

Post by CanadianSheepHunter »

Flying wires lower attach point, made these from 0.025” 6061 T6...not sure how I got the fisheyes as painters call them...scuffed with 80 grit, cleaned with MEK, then used Bonderite for 4 min with purple scuff pad, rinsed dried then soaked in Alodine for 4 min rinsed and dried BUT only 20 min later brushed on the Epoxy primer...maybe the Alodine needs time to flash off...dunno...small pieces so not worried. Next day two layers Oratex glue.
You do not have the required permissions to view the files attached to this post.
User avatar
BlainS
Seasoned Member
Posts: 50
Joined: Fri Aug 07, 2020 4:45 pm

Re: SuperStol Fabric Backing Plates & Elevator access plates

Post by BlainS »

I’m satisfied with the handle backing plates considering the different angles that need to be conformed to. Finish tape will clean it up some.
You do not have the required permissions to view the files attached to this post.
User avatar
CanadianSheepHunter
Veteran Member
Posts: 678
Joined: Thu Feb 26, 2015 1:05 pm

Re: SuperStol Fabric Backing Plates & Elevator access plates

Post by CanadianSheepHunter »

BlainS wrote:I’m satisfied with the handle backing plates considering the different angles that need to be conformed to. Finish tape will clean it up some.
Nice work !
Post Reply

Return to “Just Aircraft”