Completed the second annual today. There were no problems at all. Greased, oiled, cleaned, inspected. yada, yada. The good part was the leak down test. I had some doubt as to the results as this was the first time I had used my new L/D tester from Aircraft Tools. The airport owner wandered by so I asked him was I doing it right. He said yeah, but I should ask Steve in the hanger next door, mainly because his Subaru was barely in the acceptable range despite having far less hours than our Rotax. He was a little gripy but took the ribbing good naturedly as well as confirming my technique. Enough delay.
Cylinder #1: 80/78, Cylinder #2 80/78, Cylinder #3 80/78, Cylinder #4 80/79.
Rotax says can go as low as 80/60. Actually they said to use 87/67 but that, in my opinion, is just because it coincides with some even bar type measurement. In the good ole USA we use 80psi. Don't we? Rotax sure makes a good, tight, engine. Only 1300 hours to go to overhaul.
All I have to do now is wait for Dolly to go away and then go for my Mode C and ELT recertification and we're good for another year.
Alan
Completed annual condition inspection
For general discussion of the Just Aircraft family of aircraft.
Includes: Highlander, Escapade, Summit and SuperSTOL.
Includes: Highlander, Escapade, Summit and SuperSTOL.
Post Reply
1 post
• Page 1 of 1
Post Reply
1 post
• Page 1 of 1
Jump to
- General Aviation Discussion Forums
- ↳ Introductions
- ↳ Hangar Flying
- ↳ Tools
- ↳ Off Topic Discussions
- Homebuilt Experimental Aircraft & E-LSA Forums
- ↳ Aerocomp Aircraft
- ↳ Affordaplane
- ↳ Evans Volksplane
- ↳ Just Aircraft
- ↳ Sheepdog's Highlander Build
- ↳ YOUR LOG HERE
- ↳ Kolb Aircraft
- ↳ Montana Coyote
- ↳ Van's RV Aircraft
- ↳ Wag-Aero Group
- ↳ Wittman Aircraft
- ↳ Mike's Buttercup project
- ↳ Tony's Buttercup Project
- ↳ Eric's Buttercup Project
- ↳ Chadd's Buttercup Project
- ↳ Other Aircraft & New Kit Aircraft Designs
- ↳ Pipistrel
- ↳ Bearhawk
- ↳ Glasair Aircraft
- ↳ Quicksilver Mfg.
- ↳ Kitfox Aircraft
- ↳ KR Aircraft
- ↳ Zenith Aircraft
- ↳ Zodiac
- ↳ CH 701
- ↳ CH 750
- ↳ CH-801
- ↳ Sonex Aircraft
- ↳ Murphy Aircraft
- ↳ Pro-Composites Aircraft
- ↳ Vision Aircraft
- ↳ Personal Cruiser
- ↳ Quad City Aircraft Challenger
- ↳ RANS Aircraft
- ↳ Fisher Aircraft
- ↳ Aeropup Aircraft
- Airframe Technical Discussion Forums
- ↳ Aircraft Design
- ↳ Airframe Construction
- ↳ Firewall Forward
- ↳ Aircraft Finishing
- ↳ Flight Testing
- ↳ Props
- Powerplant Technical Discussion Forums
- ↳ Continental Engine Technical Discussions
- ↳ Corvair Engine Technical Discussions
- ↳ Diesel Engine Technical Discussions
- ↳ Jabiru Engine Technical Discussions
- ↳ Lycoming Engine Technical Discussions
- ↳ Radial Aircraft Engines
- ↳ Rotary Aircraft Engines
- ↳ Rotax Engine Technical Discussions
- ↳ Subaru Engine Technical Discussions
- ↳ Turbine Engine Technical Discussions
- ↳ UL Power Engines
- ↳ V-Twin Motorcycle Engine Technical Discussions
- ↳ VW Engine Technical Discussions
- ↳ Viking Aircraft Engines
- ↳ Yamaha Aircraft Conversions
- Electronics & Avionics Forums
- ↳ Aviation Electronics
- ↳ Avionics, Flight Instruments & EFIS
- ↳ Electrical Wiring