SuperStol Fabric Backing Plates & Elevator access plates
- CanadianSheepHunter
- Veteran Member
- Posts: 678
- Joined: Thu Feb 26, 2015 1:05 pm
Re: SuperStol Fabric Backing Plates & Elevator access plates
Flying wires lower attach point. Added after shrinking.
You do not have the required permissions to view the files attached to this post.
- CanadianSheepHunter
- Veteran Member
- Posts: 678
- Joined: Thu Feb 26, 2015 1:05 pm
Re: SuperStol Fabric Backing Plates & Elevator access plates
Flying wires lower attach point, made these from 0.025” 6061 T6...not sure how I got the fisheyes as painters call them...scuffed with 80 grit, cleaned with MEK, then used Bonderite for 4 min with purple scuff pad, rinsed dried then soaked in Alodine for 4 min rinsed and dried BUT only 20 min later brushed on the Epoxy primer...maybe the Alodine needs time to flash off...dunno...small pieces so not worried. Next day two layers Oratex glue.
You do not have the required permissions to view the files attached to this post.
- BlainS
- Seasoned Member
- Posts: 51
- Joined: Fri Aug 07, 2020 4:45 pm
Re: SuperStol Fabric Backing Plates & Elevator access plates
I’m satisfied with the handle backing plates considering the different angles that need to be conformed to. Finish tape will clean it up some.
You do not have the required permissions to view the files attached to this post.
- CanadianSheepHunter
- Veteran Member
- Posts: 678
- Joined: Thu Feb 26, 2015 1:05 pm
Re: SuperStol Fabric Backing Plates & Elevator access plates
Nice work !BlainS wrote:I’m satisfied with the handle backing plates considering the different angles that need to be conformed to. Finish tape will clean it up some.