Superstol Wing Cables/Plastic Bushings/Cable Bushings

[CanadianSheepHunter]

Page 64, third paragraph in build manual says to use a 1/2” Plastic Bushing in the rear of Rib 4, I confirmed with factory it should be 3/4”

[CanadianSheepHunter]

Left wing, rib # 4, red line pointed at black 3/4” Bushing(Manual says 1/2”) this pic from factory

[BDA]

I drilled and added 1/2” bushings for another pitot tube to use for AOA

FWIW

[CanadianSheepHunter]

Flap return spring left wing

[CanadianSheepHunter]

Rib #2 Left wing with 3/4” black Plastic Bushing toward leading edge

[CanadianSheepHunter]

Rib #3 Left Wing with 3/4” black Plastic Bushing toward leading edge, and the 1/2” black plastic Bushing in the middle of the three trailing edge black plastic bushings.

[CanadianSheepHunter]

Rib #4 Left wing with 3/4” black plastic Bushing toward leading edge and 3/4” black plastic Bushing in middle of three trailing edge bushings. Cables in pics are the Aileron cables, Flap Bellcrank pushrod not hooked up in these two pics

[CanadianSheepHunter]

Rib #5 Left wing with an extra small black plastic Bushing in trailing edge that won’t be used(was on rib from factory), the two cables continue on to Ailerons.

[CanadianSheepHunter]

Main Rib #6 Left Wing with two small black Plastic bushings at trailing edge. Showing Aileron Pulley.

[CanadianSheepHunter]

Rib #7 Left Wing with 1 1/16” Black Plastic Bushing toward leading edge, and one small black plastic Bushing toward trailing edge. My clear shrink tube is left loose for now, taped on cable and will get shrunk on the cable tail after pre cover inspection. Interceptors in this pic have been trimmed 1 1/4” off the top of them.

[CanadianSheepHunter]

Rib #8 Left wing showing Aileron/Interceptor/Spoiler Bellcrank. Note I used Galvanized cable that’s why I used Copper Nico Press sleeves. In this pic the upper sleeve was done with a single press Swage-It hand tool. The lower sleeve was done with 3 presses with my long red handled press tool from Aircraft Spruce...not sure yet if I will do the rest with single presses which is what the chart says in the AC 43.13 or the 3 presses.

[CanadianSheepHunter]

Rib #9 Left Wing

[CanadianSheepHunter]

Rib #7 Left wing with cables held snug with Aileron Bellcrank Cable arms parallel to rib. This is essentially with Aileron neutral.

[CanadianSheepHunter]

Left wing rib #7 with Aileron down 25 degrees and cables held snug for pics

[CanadianSheepHunter]

Left wing with Aileron 25 degrees down and cables held snug